Administrator Guide

Displaying Information about a Stack
To display information about the stack, use the following command.
• Display for stack-identity, status, and hardware information on every unit in a stack.
EXEC Privilege mode
show system
• Display most of the information in show system, but in a more convenient tabular form.
EXEC Privilege mode
show system brief
• Display the same information in show system, but only for the specied unit.
EXEC Privilege mode
show system stack-unit
• Display topology and stack link status for the entire stack.
EXEC Privilege mode
show system stack-ports [status | topology]
Examples of the show system Commands
Display information about a switch stack using the show system command.
The following is an example of the show system command to view the stack details.
Dell#show system
Stack MAC : 00:12:13:34:12:40
Reload-Type : normal-reload [Next boot : normal-reload]
-- Unit 3 --
Unit Type : Management Unit
Status : online
Next Boot : online
Required Type : S3048-ON - 52-port GE/TE (SG-ON)
Current Type : S3048-ON - 52-port GE/TE (SG-ON)
Master priority : 0
Hardware Rev : 0.0
Num Ports : 52
Up Time : 18 min, 28 sec
Dell Networking OS Version : 9.8(0.0P2)
Jumbo Capable : yes
POE Capable : no
FIPS Mode : disabled
Burned In MAC : 00:12:13:34:12:40
No Of MACs : 3
-- Power Supplies --
Unit Bay Status Type FanStatus FanSpeed(rpm)
------------------------------------------------------------
3 1 up AC up 8064
3 2 absent absent 0
-- Fan Status --
Unit Bay TrayStatus Fan1 Speed
------------------------------------------------------------
3 1 up up 18000
3 2 up up 18000
3 3 down
Stacking
813