Administrator Guide
NOTE: If you do not specify this option, the neighbors in the default VRF are
cleared.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format to remove a specic IPv6
neighbor.
NOTE: The :: notation species successive hexadecimal elds of zero.
interface interface To remove all neighbor entries learned on a specic interface, enter the keyword
interface then the interface type and slot/port or number information of the
interface:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
ipv6 neighbor
Congure a static entry in the IPv6 neighbor discovery.
Syntax
ipv6 neighbor [vrf vrf-name] {ipv6-address} {interface interface}
{hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6 neighbor [vrf vrf-
name] {ipv6-address} {interface interface} command.
Neighbor Discovery Protocol (NDP) 1025