Administrator Guide
Object Tracking
Object Tracking supports IPv4 and IPv6, and is available on the Dell Networking platforms.
Object tracking allows you to dene objects of interest, monitor their state, and report to a client when a change in an object’s state
occurs. The following tracked objects are supported:
• Link status of Layer 2 interfaces
• Routing status of Layer 3 interfaces (IPv4 and IPv6)
• Reachability of IPv4 and IPv6 routes
• Metric thresholds of IPv4 and IPv6 routes
You can congure client applications, such virtual router redundancy protocol (VRRP), to receive a notication when the state of a tracked
object changes.
Topics:
• IPv4 Object Tracking Commands
• IPv6 Object Tracking Commands
IPv4 Object Tracking Commands
The following section describes the IPv4 VRRP commands.
debug track
Enables debugging for tracked objects.
Syntax
debug track [all | notifications | object-id]
Parameters
all Enables debugging on the state and notications of all tracked objects.
notications Enables debugging on the notications of all tracked objects.
object-id Enables debugging on the state and notications of the specied tracked object. The
range is 1 to 500.
Defaults Enable debugging on the state and notications of all tracked objects (debug track all).
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
35
Object Tracking 1041