Administrator Guide
Version Description
7.7.1.0 Introduced on the E-Series.
Usage Information
You can apply any number of redirect-groups to an interface. A redirect list can contain any number of congured
rules. These rules includes the next-hop IP address where the incoming trac is to be redirected.
If the next hop address is reachable, trac is forwarded to the specied next hop. Otherwise, the normal routing
table is used to forward trac. When a redirect-group is applied to an interface and the next-hop is reachable, the
rules are added into the PBR CAM region. When incoming trac hits an entry in the CAM, the trac is redirected
to the corresponding next-hop IP address specied in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
The Layer2 PBR option matches the layer2 trac ow. If you un-congure this option, then the Layer2 trac is
not matched. You can apply the
l2–switch option to redirect Layer2 trac only on a VLAN interface. This VLAN
interface must be congured with an IP address for ARP resolution.
NOTE: The l2–switch option that redirects Layer2 trac is applicable only on VLAN interfaces.
The Layer3 routing is not aected on the same interface on which Layer2 PBR is applied. The port from which
Layer2 packets egress and the destination MAC are re-written from static ARP. Layer 2 packets with the re-
written destination MAC are forwarded through the outgoing port on the same incoming VLAN interface. The l2-
switch option ensures that the outgoing VLAN and MAC-SA are changed and TTL is not decremented.
Related Commands
• show cam pbr – display the content of the PBR CAM.
• show ip redirect-list – display the redirect-list conguration.
ip redirect-list
Congure a redirect list and enter REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-name Enter the name of a redirect list.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
Policy-based Routing (PBR) 1177