Administrator Guide
• You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}[track
<obj-id>] {ip-protocol-number [bit] | protocol-type} {source mask | any |
host ip-address} {destination mask | any | host ip-address} [operator]
command.
Parameters
redirect Enter the keyword redirect to assign the sequence to the redirect list.
ip-address Enter the IP address of the forwarding router.
slot/port Enter the keyword slot / port followed by the slot/port information.
tunnel Enter the keyword tunnel to congure the tunnel setting.
tunnel-id Enter the keyword tunnel-id to redirect the trac.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
ip-protocol-number Enter a number from 0 to 255 for the protocol identied in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following
TCP ags:
• ack = acknowledgement
• fin = nish (no more data from the user)
•
psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent eld
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prex format (/x).
any Enter the keyword any to specify that all trac is subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
operator (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical
operand:
• eq = equal to
• neq = not equal to
•
gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for theport command
parameter.)
1180 Policy-based Routing (PBR)