Administrator Guide
Version Description
6.1.1.0 Added support for the VLAN interface.
ip pim dr-priority
Change the designated router (DR) priority for the interface.
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0 to
4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series on port-channels and the S-Series.
Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain
the same designated router priority value, the interface with the largest interface IP address becomes the
designated router.
ip pim join-lter
Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM-SM router
from creating state based on multicast source and/or group.
Syntax
ip pim [vrf vrf-name] join-filter ext-access-list [in | out]
PIM-Sparse Mode (PIM-SM) 1191