Administrator Guide
Version Description
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-Series.
7.7.1.1 Introduced
Usage Information This command congures an expiration timer for all S.G entries, unless they are assigned to an Extended ACL.
Even though the FHR nodes act as RPs, these nodes still send Register encap messages to themselves and
expect to receive a Register stop message (for Anycast RP support). As a result, if the DLT timer expires, SG is not
deleted until the register state is deleted in the node. This register state expires 210 seconds after the last Null
register is received.
ip pim ssm-range
Specify the SSM group range using an access list.
Syntax
ip pim [vrf vrf-name] ssm-range {access_list_name}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to specify the
SSM group range for that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
access_list_name Enter the name of the access list.
Defaults Default SSM range is 232/8 and 3x/32
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON. Added support for VRF on S6000, S4810, S4820T, Z9000,
Z9500, and S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
1200 PIM-Sparse Mode (PIM-SM)