Administrator Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced.
Usage Information By default, Dell Networking OS implements an optimized ush mechanism for PVST+. This implementation helps in
ushing the MAC addresses only when necessary (and less often) allowing for faster convergence during topology
changes. However, if a standards-based ush mechanism is needed, you can turn this knob command on to enable
ushing MAC addresses after receiving every topology change notication.
vlan bridge-priority
Set the PVST+ bridge-priority for a VLAN or a set of VLANs.
S3048
Syntax
vlan vlan-range bridge-priority value
To return to the default value, use the no vlan bridge-priority command.
Parameters
vlan vlan-range Enter the keyword vlan then the VLAN numbers. The range is from 1 to 4094.
bridge-priority value Enter the keywords bridge-priority then the bridge priority value in increments of
4096. The range is from 0 to 61440. The default is 32768.
Defaults 32768
Command Modes CONFIGURATION (conf-pvst)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
1244 Per-VLAN Spanning Tree Plus (PVST+)