Administrator Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced.
Usage Information By default, when rate policing and shaping, the system does not include the Preamble, SFD, or the IFG elds.
These elds are overhead; only the elds from MAC destination address to the CRC are used for forwarding and
are included in these rate metering calculations.
Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to dene the QoS conguration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the trac this interface receives.
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p conguration on the interface, use the no dot1p-priority command.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
1250 Quality of Service (QoS)