Administrator Guide
Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.
Related Commands
• show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping on the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched trac on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
S3048–ON
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults All dot1p trac is mapped to Queue 0 unless you enable the service-class dynamic dot1p command. The
default mapping is as follows:
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Command Modes
• INTERFACE
• CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1254 Quality of Service (QoS)