Administrator Guide

Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
7.4.1.0 and 6.5.3.0 Introduced on the E-Series.
Usage Information
This command does not uniquely identify a queue, but rather identies only a set of queues. The WRED Curve is
applied to all eight ingress Multicast queues.
NOTE: The multicast-bandwidth option is not supported on queue ingress. If you attempt to use
the multicast-bandwidth option, the following reject error message is generated: %
Error:Bandwidth-percent is not allowed for ingress multicast
.
rate-police
Specify the policing functionality on incoming trac.
S3048–ON
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). Make the
following value a multiple of 64. The range is from 0 to 40000000. The default granularity
is Megabits per second (Mbps).
committed-rate Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The default is
100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to specify the peak rate in Mbps.
The range is from 0 to 40000. The default is the same as designated for committed-
rate
.
Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate. Granularity for committed-
rate and peak-rate is Mbps unless you use the kbps option.
Command Modes QOS-POLICY-IN
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Quality of Service (QoS) 1275