Administrator Guide
Related Commands
• class-map — identies the class map.
• service-policy input — applies an input policy map to the selected interface.
• service-policy output — applies an output policy map to the selected interface.
set
Mark outgoing trac with a dierentiated service code point (DSCP) or dot1p value.
S3048–ON
Syntax
set {ip-dscp value | mac-dot1p value}
Parameters
ip-dscp value (OPTIONAL) Enter the keywords ip-dscp then the IP DSCP value. The range is from 0
to 63.
mac-dot1p value Enter the keywords mac-dot1p then the dot1p value. The range is from 0 to 7.
Defaults none
Command Modes CONFIGURATION (conf-qos-policy-in)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added mac-dot1p on the C-Series and S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added support for mac-dot1p.
6.1.1.1 Introduced on the E-Series.
Usage Information
After the IP DSCP bit is set, other QoS services can then operate on the bit settings.
Quality of Service (QoS) 1281