Administrator Guide
maximum-paths
Set RIP to forward packets over multiple paths.
S3048–ON
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths commands.
Parameters
number Enter the number of paths. The range is from 1 to 16. The default is 4 paths.
Defaults 4
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information RIP supports a maximum of 16 ECMP paths.
neighbor
Dene a neighbor router with which to exchange RIP information.
S3048–ON
Syntax
neighbor ip-address
Routing Information Protocol (RIP) 1317