Administrator Guide

Version Description
7.4.1.0 Introduced
Usage Information Dell Networking OS must have the default CAM prole with the default microcode before you enable L2PT.
protocol-tunnel rate-limit
Enable trac rate limiting per box.
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate command.
Parameters
rate Enter the rate in frames per second. The range is from 75 to 3000. The default is 75.
Defaults 75 frames per second.
Command Modes CONF-IF-VLAN-STACK
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and E-Series. Maximum rate limit on E-Series reduced from
4000 to 3000.
7.4.1.0 Introduced
Example
Dell(conf-if-vl-2)# vlan-stack compatible
Dell(conf-if-vl-2-stack)#protocol-tunnle rate-limit 100 <<<<<<<< VLAN stack
mode
Dell(conf-if-vl-2-stack)#show config
!
interface Vlan 2
no ip address
mtu 1000
vlan-stack compatible
protocol-tunnel rate-limit 100
shutdown
Service Provider Bridging 1469