Administrator Guide

source-interface (OPTIONAL) Enter the keywords /source-interface then the interface information
to include the source interface. Enter the following keywords and the interface
information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a Null interface, enter the keyword null then the Null interface number.
• For a port channel interface, enter the keywords port-channel then a number.
• For Tunnel interface types, enter the keyword tunnel then the slot/ port
information. The range is from 1 to 16383.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810. Added support for source-interface for link-local IPv6
addressing.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series (IPv6). Increased the number of VLANs to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series (IPv4).
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and added support for IPv6 address on the E-Series only.
Usage Information
The VRF congured using this command has a higher precedence than a VRF congured using the ip telnet
vrf vrf-name command. If you do not use the VRF attribute in this command, then TELENT client uses the
VRF congured using the
ip telnet vrf vrf-name command.
150 Control and Monitoring