Administrator Guide

Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810
8.5.1.0 Added support for 4-port 40G line cards.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information To enable this snmp-server trap-source command, congure an IP address on the interface and enable the
interface congured as an SNMP trap source.
Related Commands
• snmp-server community — sets the community string.
snmp-server user
Congure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port port-
number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv {des56
| aes128} priv password] [access access-list-name | ipv6 access-list-name |
access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name remote
ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha}
auth-password] [priv {des56 | aes128} priv password] [access access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that connects to
the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The following
groups are created for mapping to read/write community/security-names (defaults):
Simple Network Management Protocol (SNMP) and Syslog 1501