Administrator Guide

• For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information Syslog messages contain the IP address of the interface used to egress the router. By conguring the logging
source-interface command, the Syslog packets contain the IP address of the interface congured.
Related Commands
• logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and Dell Networking OS output.
Syntax
logging synchronous [level level | all] [limit number-of-buffers]
To disable message synchronization, use the no logging synchronous [level level | all]
[limit number-of-buffers] command.
1522 Simple Network Management Protocol (SNMP) and Syslog