Administrator Guide
Version Description
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
virtual-ip
Congure a virtual IP address for the active management interface. You can congure virtual addresses both for IPv4 and IPv6
independently.
Syntax
virtual-ip {ipv4-address | ipv6-address}
To return to the default, use the no virtual-ip {ipv4-address | ipv6-address} command.
Parameters
ipv4-address Enter the IP address of the active management interface in a dotted decimal format
(A.B.C.D.).
ipv6-address Enter an IPv6 address of the active management interface, in the x:x:x:x::x format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information You can congure both IPv4 and IPv6 virtual addresses simultaneously, but only one of each. Each time this
command is issued, it replaces the previously congured address of the same family, IPv4 or IPv6. The no
Control and Monitoring 155