Administrator Guide

To disable storm-control for multicast trac into the network, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d in
Enter the packets per second of multicast trac allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-MUX
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the C-series and S-Series.
Usage Information Broadcast trac (all 0xFs) should be counted against the broadcast storm control meter, not against the multicast
storm control meter. It is possible, however, that some multicast control trac may get dropped when storm
control thresholds are exceeded.
storm-control multicast (Interface)
Congure the percentage of multicast trac allowed on an C-Series or S-Series interface (ingress only) network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d in
Enter the packets per second of broadcast trac allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Storm Control 1553