Administrator Guide

vlan-stack protocol-type
Dene the stackable VLAN tag protocol identier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not congure this
command, the Dell Networking OS assigns the value 0x9100.
Syntax
vlan-stack protocol-type number
Parameters
number Enter the hexadecimal number as the stackable VLAN tag.
You may specify both bytes of the 2-byte S-Tag TPID. The range is from 0 to FFFF. The
default is 9100.
Defaults 0x9100
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series. C-Series and S-Series accept both bytes of the 2-byte S-Tag
TPID.
8.2.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage Information
For specic interoperability limitations regarding the S-Tag TPID, see the Dell Networking OS Conguration Guide.
The four characters you may enter are shown in the following table.
Number Resulting TPID
1 0x0001
10 0x0010
81 0x0081
VLAN Stacking 1637