Administrator Guide

• deny (for Extended MAC ACLs)
• permit (for Standard IP ACLs)
• permit arp (for Extended MAC ACLs)
• permit ether-type (for Extended MAC ACLs)
• permit icmp (for Extended IP ACLs)
• permit udp (for Extended IP ACLs)
• permit (for Extended IP ACLs)
• permit (for Standard MAC ACLs)
• seq (for Standard MAC ACLs)
• permit tcp (for Extended IP ACLs)
• seq arp (for Extended MAC ACLs)
• seq ether-type (for Extended MAC ACLs)
• seq (for IP ACLs)
• seq (for IPv6 ACLs)
• permit udp (for IPv6 ACLs)
• permit tcp (for IPv6 ACLs)
• permit icmp (for IPv6 ACLs)
• permit (for IPv6 ACLs)
• deny udp (for IPv6 ACLs)
• deny tcp (for IPv6 ACLs)
• deny icmp (for Extended IPv6 ACLs)
• deny (for IPv6 ACLs)
Commands Common to all ACL Types
The following commands are available within each ACL mode and do not have mode-specic options. Some commands in this chapter may
use similar names, but require dierent options to support the dierent ACL types (for example, the deny and permit commands).
remark
Enter a description for an ACL entry.
Syntax
remark [remark-number] [description]
Parameters
remark-number Enter the remark number. The range is from 0 to 65535 for MAC ACL and 0 to
4294967290 for IP ACL.
NOTE: You can use the same sequence number for the remark and an ACL
rule.
description Enter a description of up to 80 characters.
Defaults Not congured.
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
Access Control Lists (ACL) 183