Administrator Guide

seq
Assign a sequence number to a deny or permit lter in an IP access list while creating the lter.
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host ip-address}}
[count [byte] | log] [dscp value] [ecn value] [fragments] [monitor [session-
ID]] [no-drop] [order]
To delete a lter, use the no seq sequence-number command.
Parameters
sequence-number Enter a number from 0 to 4294967290.
deny Enter the keyword deny to congure a lter to drop packets meeting this condition.
permit Enter the keyword permit to congure a lter to forward packets meeting this criteria.
source Enter an IP address in dotted decimal format of the network from which the packet was
received.
mask (OPTIONAL) Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when
specied in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address or hostname.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
bytes (OPTIONAL) Enter the keyword bytes to count bytes the lter processes.
log (OPTIONAL) Enter the keyword log to enter ACL matches in the log.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. The range is
from 0 to 63.
ecn (OPTIONAL) Enter the keyword ecn to match to the ECN values. The range is from 0 to
3.
order (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL entry. The
range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the keyword order, the ACLs have the
lowest order by default (255).
monitor (OPTIONAL) Enter the keyword monitor then the session–ID to describe the trac
that you want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. The session–ID range is from 0 to 65535.
NOTE: For more information, see “Flow-based Monitoring” in the Port
Monitoring section of the Dell Networking OS Conguration Guide .
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not congured
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
198 Access Control Lists (ACL)