Administrator Guide
• Passive — passive system does not initiate a session. It only responds to a request
for session initialization from the active system.
The default is Active.
Defaults See Parameters.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.0.0.0 Introduced on Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on S4810.
8.2.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the E-Series.
Usage Information
This command provides the exibility to ne-tune the timer values based on individual interface needs when ISIS
BFD is congured in CONFIGURATION mode. Any timer values specied with this command overrides timers set
using the bfd all-neighbors command. Using the no form of this command does not disable BFD if BFD is
congured in CONFIGURATION mode.
To disable BFD on a specic interface while BFD is congured in CONFIGURATION mode, use the keyword
disable.
neighbor bfd
Explicitly enable a BFD session with a BGP neighbor or a BGP peer group.
Syntax
neighbor {ip-address | peer-group-name} bfd
Parameters
ip-address Enter the IP address of the BGP neighbor that you want to explicitly enable for BFD
sessions in dotted decimal format (A.B.C.D).
peer-group-name Enter the name of the peer group that you want to explicitly enable for BFD sessions.
Defaults None
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
336 Bidirectional Forwarding Detection (BFD)