Administrator Guide
Parameters
ip-address Enter the IP address of the neighbor to remove the private AS numbers.
peer-group-name Enter the name of the peer group to remove the private AS numbers.
Defaults Disabled (that is, private AS number are not removed).
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Usage Information
Applies to EBGP neighbors only.
Congure your system to accept 4-byte formats before entering a 4 byte AS Number.
If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP neighbor, the
private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS numbers only
if they follow the confederation numbers in the AS path.
Private AS numbers are from 64512 to 65535 (2 byte).
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in | out}
To remove the route map, use the no neighbor {ip-address | peer-group-name} route-map
map-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
400 Border Gateway Protocol