Administrator Guide
• Hash multi-protocol label switching (MPLS) packets based on source and destination IP addresses for link aggregation groups (LAGs).
• Hash based on bidirectional ow for LAGs.
• Optimize the virtual local area network (VLAN) ACL Group feature, which permits group VLANs for IP egress ACLs.
Important Points to Remember
• Dell Networking OS supports CAM allocations on the C-Series and S-Series.
• All line cards within a single system must have the same CAM prole (including CAM sub-region congurations); this prole must match
the system CAM prole (the prole on the primary route processor module [RPM]).
• Dell Networking OS automatically recongures the CAM prole on line cards and the secondary RPM to match the system CAM prole
by saving the correct prole on the card and then rebooting it.
• The CAM conguration is applied to the entire system when you use the CONFIGURATION mode commands. Save the running-
conguration to aect the change.
• When budgeting your CAM allocations for ACLs and quality of service (QoS) congurations, remember that ACL and QoS rules might
consume more than one CAM entry depending on complexity. For example, transmission control protocol (TCP) and user datagram
protocol (UDP) rules with port range options might require more than one CAM entry.
• After you install a secondary RPM, copy the running-conguration to the startup-conguration so that the new RPM has the correct
CAM prole.
• You MUST save your changes and reboot the system for CAM proling or allocations to take eect.
cam-acl (Conguration)
Select the default CAM allocation settings or recongure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and Layer 3
(IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet Connectivity Fault Management
(CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number
l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos number]
ecfmacl number [nlbclusteracl number] ipv4pbr number }openflow number | fcoe
number} [iscsioptacl number] [vrfv4acl number]
Parameters
default Use the default CAM prole settings and set the CAM as follows:
• L2Acl : 6
• IPV4Acl : 4
• IPV6Acl : 0
• IPV4Qos : 2
• L2Qos : 1
• L2PT : 0
• IpMacAcl : 0
• VmanQos : 0
• VmanDualQos : 0
• EcfmAcl : 0
• nlbclusteracl: 0
• FcoeAcl : 0
• iscsiOptAcl : 0
• ipv4pbr : 0
Content Addressable Memory (CAM) 467