Administrator Guide
host
For manual (rather than automatic) congurations, assign a host to a single-address pool.
Syntax
host address
Parameters
address/mask Enter the host IP address and subnet mask.
Defaults None
Command Modes DHCP <POOL>
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
lease
Specify a lease time for the addresses in a pool.
Syntax
lease {days [hours] [minutes] | infinite}
Parameters
days Enter the number of days of the lease. The range is from 0 to 31.
hours Enter the number of hours of the lease. The range is from 0 to 23.
minutes Enter the number of minutes of the lease. The range is from 0 to 59.
518 Dynamic Host Conguration Protocol (DHCP)