Administrator Guide
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
control-vlan vlan-id Enter the keyword control-vlan then the VLAN ID. The range is from 1 to 4094.
Defaults None
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage Information This command causes the Ring Manager to take ownership of the two ports after IFM validates the conguration.
Ownership is relinquished for a port only when the interface does not play a part in any control VLAN, that is, the
interface does not belong to any ring.
Related Commands
• show frrp — display the Resilient Ring Protocol conguration information.
member-vlan
Specify the member VLAN identication numbers.
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Force10 Resilient Ring Protocol (FRRP) 571