Administrator Guide
minimum-links
Congure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG to be also in “oper up” status.
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up” status. The range is from 1 to
16. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Usage Information
If you use this command to congure the minimum number of links in a LAG that must be in “oper up” status, the
LAG must have at least that number of “oper up” links before it can be declared as up. For example, if the required
minimum is four, and only three are up, the LAG is considered down.
port-channel failover-group
To congure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group command.
Interfaces 709