Administrator Guide

Port Channels:
• All members must have the same link MTU value and the same IP MTU value.
• The Port Channel link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values
congured on the channel members. For example, if the members have a link MTU of 2100 and an IP MTU
2000, the Port Channel’s MTU values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
VLANs:
• All members of a VLAN must have same IP MTU value.
• Members can have dierent Link MTU values. Tagged members must have a link MTU 4 bytes higher than
untagged members to account for the packet tag.
• The VLAN link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values congured on
the VLAN members. For example, the VLAN contains tagged members with Link MTU of 1522 and IP MTU of
1500 and untagged members with Link MTU of 1518 and IP MTU of 1500. The VLAN’s Link MTU cannot be
higher than 1518 bytes and its IP MTU cannot be higher than 1500 bytes.
The following describes the dierence between Link MTU and IP MTU.
Layer 2
Overhead
Dierence between Link MTU and IP MTU
Ethernet
(untagged)
18 bytes
VLAN Tag Tag 22 bytes
Untagged Packet
with VLAN-Stack
Header
22 bytes
Tagged Packet with
VLAN-Stack
Header
26 bytes
Related Commands
• mtu — set the link MTU for an Ethernet interface.
ip name-server
Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order of their use.
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
Parameters
ipv4-address Enter the IPv4 address, in dotted decimal format, of the name server to be used.
ipv4-address2...
ipv4-address6
(OPTIONAL) Enter up ve more IPv4 addresses, in dotted decimal format, of name
servers to be used. Separate the addresses with a space.
Defaults No name servers are congured.
IPv4 Routing 761