Administrator Guide
vlan Enter the keyword vlan to specify a vlan interface.
gigbitethernet Enter the keyword gigabitethernet to specify a one Gigabit Ethernet interface.
tengigabitethernet Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet interfaces. Introduced on
the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol
route) is preferred over the Management Static route. Also, Management static routes and the Management
Connected prex are not reected in the hardware routing tables. Separate routing tables are maintained for IPv4
and IPv6 management routes. This command manages both tables.
Related Commands
• interface ManagementEthernet — congure the Management port on the system (either the Primary or
Standby RPM).
• speed (Management interface) — set the speed for the Management interface.
show arp
Display the ARP table.
Syntax
show arp [vrf vrf-name] [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [retries] [static | dynamic]
[inspection {database | statistics][summary]
IPv4 Routing 771