Administrator Guide

Version Description
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip route summary shown in the following example.
Column Heading Description
Route Source Identies how the route is congured in Dell Networking OS.
Active Routes Identies the best route if a route is learned from two protocol sources.
Non-active Routes Identies the back-up routes when a route is learned by two dierent protocols. If the
best route or active route goes down, the non-active route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are congured and routes are advertised, then
information on those routes is displayed.
Total 1388 active... Displays the number of active and non-active routes and the memory usage of those
routes. If there are no routes congured in the Dell Networking OS, this line does not
appear.
Example
Dell> show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
Dell>
Related Commands
• show ip route — display information about the routes found in the switch.
show ip trac
View IP, ICMP, UDP, TCP and ARP trac statistics.
Syntax
show ip traffic [all | cp | rp1 | rp2]
NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from all processors. If you do not
enter a keyword, you also view all statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only statistics from the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route Processor 1.
794 IPv4 Routing