Administrator Guide
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
7.5.1.0 Added option for SA upper limit and the description option.
6.2.1.1 Introduced
Usage Information
The connect-source option is used to supply a source IP address for the TCP connection. When an interface is
specied using the connect-source option, the primary congured address on the interface is used.
If the total number of SA messages received from the peer is already larger than the limit when this command is
applied, those SA messages continue to be accepted. To enforce the limit in such situation, use the clear ip
msdp peer command to reset the peer.
Related Commands
• ip msdp sa-limit — congure the MSDP SA Limit.
• clear ip msdp peer — clear the MSDP peer.
• show ip msdp — display the MSDP information.
ip msdp redistribute
Filter local PIM SA entries in the SA cache. SAs which the ACL denies time out and are not refreshed. Until they time out, they continue to
reside in the MSDP SA cache.
Syntax
ip msdp redistribute [list acl-name]
Parameters
list acl-name Enter the name of an extended ACL that contains permitted SAs. If you do not use this
option, all local entries are blocked.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Multicast Source Discovery Protocol (MSDP) 989