Concept Guide

The following example shows verifying the BGP conguration using the show running-config bgp command..
DellEMC#show running-config bgp
!
router bgp 65550
neighbor 20.20.20.1 remote-as 20
neighbor 20.20.20.1 no shutdown
DellEMC#
Examples of the show ip bgp Commands
The following example shows the show ip bgp summary command output (4–byte AS number displays).
R2#show ip bgp summary
BGP router identifier 1.1.1.1, local 65550
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
1 neighbor(s) using 40960 bytes of memory
Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx
20.20.20.1 200 0 0 0 0 0 00:00:00 0
For the router’s identier, Dell EMC Networking OS uses the highest IP address of the Loopback interfaces congured. Because Loopback
interfaces are virtual, they cannot go down, thus preventing changes in the router ID. If you do not congure Loopback interfaces, the
highest IP address of any interface is used as the router ID.
To view the status of BGP neighbors, use the show ip bgp neighbors command in EXEC Privilege mode as shown in the rst
example. For BGP neighbor conguration information, use the
show running-config bgp command in EXEC Privilege mode as
shown in the second example.
NOTE
: The showconfig command in CONFIGURATION ROUTER BGP mode gives the same information as the show
running-config bgp command.
The following example displays two neighbors: one is an external internal BGP neighbor and the second one is an internal BGP neighbor.
The rst line of the output for each neighbor displays the AS number and states whether the link is an external or internal (shown in bold).
The third line of the show ip bgp neighbors output contains the BGP State. If anything other than ESTABLISHED is listed, the
neighbor is not exchanging information and routes. For more information about using the show ip bgp neighbors command, refer to
the
Dell EMC Networking OS Command Line Interface Reference Guide.
The following example shows the show ip bgp neighbors command output.
DellEMC#show ip bgp neighbors
BGP neighbor is 20.20.20.1, remote AS 200, external link
BGP remote router ID 1.1.1.1
BGP state ESTABLISHED, in this state for 00:05:22
Last read 00:00:00, Last write 00:00:07
Hold time is 90, keepalive interval is 30 seconds
Received 18 messages, 0 in queue
7 opens, 6 notifications, 0 updates
5 keepalives, 0 route refresh requests
Sent 26 messages, 0 in queue
7 opens, 0 notifications, 0 updates
19 keepalives, 0 route refresh requests
Route refresh request: received 0, sent messages 0
Minimum time between advertisement runs is 30 seconds
Minimum time before advertisements start is 0 seconds
For address family: IPv4 Unicast
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
InQ : Added 0, Replaced 0, Withdrawn 0
OutQ : Added 0, Withdrawn 0
Allow local AS number 0 times in AS-PATH attribute
Prefixes accepted 0, withdrawn 0 by peer, martian prefixes ignored 0
Prefixes advertised 0, denied 0, withdrawn 0 from peer
190
Border Gateway Protocol (BGP)