Concept Guide

• After the virtual IP address is removed, the system is accessible through the native IP address of the primary RPM’s management
interface.
• Primary and secondary management interface IP and virtual IP must be in the same subnet.
To view the Primary RPM Management port, use the show interface Managementethernet command in EXEC Privilege mode. If
there are two RPMs, you cannot view information on that interface.
Conguring a Management Interface on an Ethernet Port
You can manage the system through any port using remote access such as Telnet.
To congure an IP address for the port, use the following commands. There is no separate management routing table, so congure all
routes in the IP routing table (the ip route command).
• Congure an IP address.
INTERFACE mode
ip address ip-address mask
• Enable the interface.
INTERFACE mode
no shutdown
• The interface is the management interface.
INTEFACE mode
description
Example of the show interface and show ip route Commands
To display the conguration for a given port, use the show interface command in EXEC Privilege mode, as shown in the following
example. To display the routing table, use the show ip route command in EXEC Privilege mode.
DellEMC#show int gig 1/1
GigabitEthernet 1/1 is up, line protocol is up
Description: This is the Managment Interface
Hardware is DellEMCEth, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.241/23
[output omitted]
DellEMC#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.1/0 via 10.11.131.254, Gi 1/1 1/0 1d2h
C 10.11.130.0/23 Direct, Gi 0/48 0/0 1d2h
DellEMC#
VLAN Interfaces
VLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels can be members of VLANs.
For more information about VLANs and Layer 2, see Layer 2 and Virtual LANs (VLANs).
356
Interfaces