Concept Guide

MD5

DellEMC# verify md5 flash://file-name 275ceb73a4f3118e1d6bcf7d75753459

SHA256

DellEMC# verify sha256 flash://file-name

e6328c06faf814e6899ceead219afbf9360e986d692988023b749e6b2093e933

Using HTTP for File Transfers

Stating with Release 9.3(0.1), you can use HTTP to copy les or conguration details to a remote server. To transfer les to an external

server, use the copy source-le-url http://host[:port]/le-path command.

Enter the following source-le-url keywords and information:

• To copy a le from the internal FLASH, enter ash:// followed by the lename.

• To copy the running conguration, enter the keyword running-cong.

• To copy the startup conguration, enter the keyword startup-cong.

• To copy a le on the USB device, enter usbash:// followed by the lename.

In the Dell EMC Networking OS release 9.8(0.0), HTTP services support the VRF-aware functionality. If you want the HTTP server to use a

VRF table that is attached to an interface, congure that HTTP server to use a specic routing table. You can use the ip http vrf

command to inform the HTTP server to use a specic routing table. After you congure this setting, the VRF table is used to look up the

destination address.

NOTE

: To enable HTTP to be VRF-aware, as a prerequisite you must rst dene the VRF.

You can specify either the management VRF or a nondefault VRF to congure the VRF awareness setting.

When you specify the management VRF, the copy operation that is used to transfer les to and from an HTTP server utilizes the VRF table

corresponding to the Management VRF to look up the destination. When you specify a nondefault VRF, the VRF table corresponding to

that nondefault VRF is used to look up the HTTP server.

However, these changes are backward-compatible and do not aect existing behavior; meaning, you can still use the ip http source-

interface command to communicate with a particular interface even if no VRF is congured on that interface

NOTE

: If the HTTP service is not VRF-aware, then it uses the global routing table to perform the look-up.

To enable an HTTP client to look up the VRF table corresponding to either management VRF or any nondefault VRF, use the ip http

vrf

command in CONFIGURATION mode.

• Congure an HTTP client with a VRF that is used to connect to the HTTP server.

CONFIGURATION MODE

DellEMC(conf)#ip http vrf {management | <vrf-name>}

Getting Started