Setup Guide

• Establish sessions with all IS-IS neighbors.
ROUTER-ISIS mode
bfd all-neighbors
• Establish sessions with IS-IS neighbors on a single interface.
INTERFACE mode
isis bfd all-neighbors
Example of Verifying Sessions with IS-IS Neighbors
To view the established sessions, use the show bfd neighbors command.
The bold line shows that IS-IS BFD sessions are enabled.
R2(conf-router_isis)#bfd all-neighbors
R2(conf-router_isis)#do show bfd neighbors
* - Active session role
Ad Dn - Admin Down
C - CLI
I - ISIS
O - OSPF
R - Static Route (RTM)
LocalAddr RemoteAddr Interface State Rx-int Tx-int Mult Clients
* 2.2.2.2 2.2.2.1 Gi 2/1 Up 100 100 3 I
Changing IS-IS Session Parameters
BFD sessions are congured with default intervals and a default role.
The parameters that you can congure are: Desired TX Interval, Required Min RX Interval, Detection Multiplier, and system role. These
parameters are congured for all IS-IS sessions or all IS-IS sessions out of an interface. If you change a parameter globally, the change
aects all IS-IS neighbors sessions. If you change a parameter at the interface level, the change aects all IS-IS sessions on that interface.
To change parameters for all IS-IS sessions or for IS-IS sessions on a single interface, use the following commands.
To view session parameters, use the show bfd neighbors detail command, as shown in Verifying BFD Sessions with BGP
Neighbors Using the show bfd neighbors Command.
• Change parameters for all IS-IS sessions.
ROUTER-ISIS mode
bfd all-neighbors interval milliseconds min_rx milliseconds multiplier value role [active |
passive]
• Change parameters for IS-IS sessions on a single interface.
INTERFACE mode
isis bfd all-neighbors interval milliseconds min_rx milliseconds multiplier value role [active
| passive]
Disabling BFD for IS-IS
If you disable BFD globally, all sessions are torn down and sessions on the remote system are placed in a Down state.
If you disable BFD on an interface, sessions on the interface are torn down and sessions on the remote system are placed in a Down state.
Disabling BFD does not trigger a change in BFD clients; a nal Admin Down packet is sent before the session is terminated.
To disable BFD sessions, use the following commands.
• Disable BFD sessions with all IS-IS neighbors.
156
Bidirectional Forwarding Detection (BFD)