Users Guide

CONFIG-COMMUNITY-LIST mode
{permit | deny} {{rt | soo} {ASN:NN | IPADDR:N} | regex REGEX-LINE}
Filter routes based on the type of extended communities they carry using one of the following keywords:
• rt: route target.
• soo: route origin or site-of-origin. Support for matching extended communities against regular expression is also supported. Match
against a regular expression using the following keyword.
• regexp: regular expression.
To set or modify an extended community attribute, use the set extcommunity {rt | soo} {ASN:NN | IPADDR:NN}
command.
To view the configuration, use the show config command in CONFIGURATION COMMUNITY-LIST or CONFIGURATION
EXTCOMMUNITY LIST mode or the show ip {community-lists | extcommunity-list} command in EXEC Privilege mode.
Dell#show ip community-lists
ip community-list standard 1
deny 701:20
deny 702:20
deny 703:20
deny 704:20
deny 705:20
deny 14551:20
deny 701:112
deny 702:112
deny 703:112
deny 704:112
deny 705:112
deny 14551:112
deny 701:667
deny 702:667
deny 703:667
deny 704:666
deny 705:666
deny 14551:666
Dell#
Filtering Routes with Community Lists
To use an IP community list or IP extended community list to filter routes, you must apply a match community filter to a route map and
then apply that route map to a BGP neighbor or peer group.
1. Enter the ROUTE-MAP mode and assign a name to a route map.
CONFIGURATION mode
route-map map-name [permit | deny] [sequence-number]
2. Configure a match filter for all routes meeting the criteria in the IP community or IP extended community list.
CONFIG-ROUTE-MAP mode
match {community community-list-name [exact] | extcommunity extcommunity-list-name [exact]}
3. Return to CONFIGURATION mode.
CONFIG-ROUTE-MAP mode
exit
4. Enter ROUTER BGP mode.
CONFIGURATION mode
router bgp as-number
AS-number: 0 to 65535 (2-Byte) or 1 to 4294967295 (4-Byte) or 0.1 to 65535.65535 (Dotted format)
5. Apply the route map to the neighbor or peer group’s incoming or outgoing routes.
CONFIG-ROUTER-BGP mode
neighbor {ip-address | peer-group-name} route-map map-name {in | out}
To view the BGP configuration, use the show config command in CONFIGURATION ROUTER BGP mode. To view a route map
configuration, use the show route-map command in EXEC Privilege mode.
180
Border Gateway Protocol IPv4 (BGPv4)