Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

The bold line shows the new port-control state.

Dell(conf-if-Gi-1/1)#dot1x port-control force-authorized

Dell(conf-if-Gi-1/1)#show dot1x interface GigabitEthernet 1/1

802.1x information on Gi 1/1:

-----------------------------

Dot1x Status: Enable

Port Control: FORCE_AUTHORIZED

Port Auth Status: UNAUTHORIZED

Re-Authentication: Disable

Untagged VLAN id: None

Tx Period: 90 seconds

Quiet Period: 120 seconds

ReAuth Max: 2

Supplicant Timeout: 30 seconds

Server Timeout: 30 seconds

Re-Auth Interval: 3600 seconds

Max-EAP-Req: 10

Auth Type: SINGLE_HOST

Auth PAE State: Initialize

Backend State: Initialize

Auth PAE State: Initialize

Backend State: Initialize

Re-Authenticating a Port

You can configure the authenticator for periodic re-authentication.

After the supplicant has been authenticated, and the port has been authorized, you can configure the authenticator to re-authenticate the

supplicant periodically. If you enable re-authentication, the supplicant is required to re-authenticate every 3600 seconds by default, and

you can configure this interval. You can configure the maximum number of re-authentications as well.

To configure re-authentication time settings, use the following commands:

• Configure the authenticator to periodically re-authenticate the supplicant.

INTERFACE mode

dot1x reauthentication [interval] seconds

The range is from 1 to 65535.

The default is 3600.

• Configure the maximum number of times the supplicant can be re-authenticated.

INTERFACE mode

dot1x reauth-max number

The range is from 1 to 10.

The default is 2.

The bold lines show that re-authentication is enabled and the new maximum and re-authentication time period.

Dell(conf-if-gi-1/1)#dot1x reauthentication interval 7200

Dell(conf-if-gi-1/1)#dot1x reauth-max 10

Dell(conf-if-gi-1/1)#do show dot1x interface GigabitEthernet 1/1