Service Manual

Three values are given within the trap messages: MD Index, MA Index, and MPID. You can reference these
values against the output of the show ethernet cfm domain and show ethernet cfm
maintenance-points local mep commands
To enable CFM SNMP traps, use the following command.
• Enable SNMP trap messages for Ethernet CFM.
CONFIGURATION mode
snmp-server enable traps ecfm
Example of Viewing CFM SNMP Trap Information
Dell#show ethernet cfm maintenance-points local mep
--------------------------------------------------------------------
MPID Domain Name Level Type Port CCM-Status
MA Name VLAN Dir MAC
---------------------------------------------------------------------
100 cfm0 7 MEP Te 4/10 Enabled
test0 10 DOWN 00:01:e8:59:23:45
Dell(conf-if-te-1/6)#do show ethernet cfm domain
Domain Name: My_Name
MD Index: 1
Level: 0
Total Service: 1
Services
MA-Index MA-Name VLAN CC-Int X-CHK Status
1 test 0 1s enabled
Domain Name: Your_Name
MD Index: 2
Level: 2
Total Service: 1
Services
MA-Index MA-Name VLAN CC-Int X-CHK Status
1 test 100 1s enabled
Displaying Ethernet CFM Statistics
To display Ethernet CFM statistics, use the following commands.
• Display MEP CCM statistics.
EXEC Privilege mode
show ethernet cfm statistics [domain {name | level} vlan-id vlan-id mpid mpid
• Display CFM statistics by port.
EXEC Privilege mode
show ethernet cfm port-statistics [interface]
Example of Viewing CFM Statistics
Dell# show ethernet cfm statistics
Domain Name: Customer
102
802.1ag