Service Manual

Slot/Port[/subport], Range: Slot and Port ID for the interface. Range is entered Slot/Port[/
subport]-Slot/Port[/subport].
3. Assign the Primary and Secondary ports and the control VLAN for the ports on the ring.
CONFIG-FRRP mode.
interface primary interface slot/port[/subport] secondary int slot/port[/
subport] control-vlan vlan id
Interface:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/
port[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port
information.
Slot/Port[/subport], Range: Slot and Port ID for the interface. Range is entered Slot/Port[/
subport]-Slot/Port[/subport].
VLAN ID: The VLAN identification of the control VLAN.
4. Configure the Master node.
CONFIG-FRRP mode.
mode master
5. Identify the Member VLANs for this FRRP group.
CONFIG-FRRP mode.
member-vlan vlan-id {range}
VLAN-ID, Range: VLAN IDs for the ring’s member VLANS.
6. Enable FRRP.
CONFIG-FRRP mode.
no disable
Configuring and Adding the Member VLANs
Control and member VLANS are configured normally for Layer 2. Their status as Control or Member is
determined at the FRRP group commands.
For more information about configuring VLANS in Layer 2 mode, refer to the Layer 2 chapter.
Be sure to follow these guidelines:
• All VLANS must be in Layer 2 mode.
• Tag control VLAN ports. Member VLAN ports, except the Primary/Secondary interface, can be tagged
or untagged.
• The control VLAN must be the same for all nodes on the ring.
To create the Members VLANs for this FRRP group, use the following commands on all of the Transit
switches in the ring.
1. Create a VLAN with this ID number.
CONFIGURATION mode.
interface vlan vlan-id
382
Force10 Resilient Ring Protocol (FRRP)