Service Manual

Table Of Contents
8. (Optional) Set the aging time for iSCSI session monitoring.
CONFIGURATION mode
[no] iscsi aging time time.
The range is from 5 to 43,200 minutes.
The default is 10 minutes.
9. (Optional) Configures DCBX to send iSCSI TLV advertisements.
LLDP CONFIGURATION mode or INTERFACE LLDP CONFIGURATION mode
[no] advertise dcbx-app-tlv iscsi.
You can send iSCSI TLVs either globally or on a specified interface. The interface configuration takes
priority over global configuration.
The default is Enabled.
10. (Optional) Configures the advertised priority bitmap in iSCSI application TLVs.
LLDP CONFIGURATION mode
[no] iscsi priority-bits.
The default is 4 (0x10 in the bitmap).
11. (Optional) Configures the auto-detection of Compellent arrays on a port.
INTERFACE mode
[no] iscsi profile-compellent.
The default is: Compellent disk arrays are not detected.
Displaying iSCSI Optimization Information
To display information on iSCSI optimization, use the following show commands.
Display the currently configured iSCSI settings.
show iscsi
Display information on active iSCSI sessions on the switch.
show iscsi sessions
Display detailed information on active iSCSI sessions on the switch . To display detailed information
on specified iSCSI session, enter the session’s iSCSI ID.
show iscsi sessions detailed [session isid]
Display all globally configured non-default iSCSI settings in the current Dell Networking OS session.
show run iscsi
Examples of the show iscsi Commands
The following example shows the show iscsi command.
Dell#show iscsi
iSCSI is enabled
iSCSI session monitoring is disabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
512
iSCSI Optimization