Setup Guide

Conguring Authentication Passwords
You can assign an authentication password for routers in Level 1 and for routers in Level 2.
Because Level 1 and Level 2 routers do not communicate with each other, you can assign dierent passwords for Level 1 routers and for
Level 2 routers. However, if you want the routers in the level to communicate with each other, congure them with the same password.
To congure a simple text password, use the following commands.
Congure authentication password for an area.
ROUTER ISIS mode
area-password [hmac-md5] password
The Dell OS supports HMAC-MD5 authentication.
This password is inserted in Level 1 LSPs, Complete SNPs, and Partial SNPs.
Set the authentication password for a routing domain.
ROUTER ISIS mode
domain-password [encryption-type | hmac-md5] password
The Dell OS supports both DES and HMAC-MD5 authentication methods.
This password is inserted in Level 2 LSPs, Complete SNPs, and Partial SNPs.
To view the passwords, use the show config command in ROUTER ISIS mode or the show running-config isis command in
EXEC Privilege mode.
To remove a password, use either the no area-password or no domain-password commands in ROUTER ISIS mode.
Setting the Overload Bit
Another use for the overload bit is to prevent other routers from using this router as an intermediate hop in their shortest path rst (SPF)
calculations. For example, if the IS-IS routing database is out of memory and cannot accept new LSPs, Dell EMC Networking OS sets the
overload bit and IS-IS trac continues to transit the system.
To set or remove the overload bit manually, use the following commands.
Set the overload bit in LSPs.
ROUTER ISIS mode
set-overload-bit
This setting prevents other routers from using it as an intermediate hop in their shortest path rst (SPF) calculations.
Remove the overload bit.
ROUTER ISIS mode
no set-overload-bit
Example of Viewing the Overload Bit Setting
When the bit is set, a 1 is placed in the OL column in the show isis database command output. The overload bit is set in both the
Level-1 and Level-2 database because the IS type for the router is Level-1-2.
DellEMC#show isis database
IS-IS Level-1 Link State Database
LSPID LSP Seq Num LSP Checksum LSP Holdtime ATT/P/OL
B233.00-00 0x00000003 0x07BF 1074 0/0/0
Intermediate System to Intermediate System
539