Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON
371372373374375376377378379380
Table Of Contents
Active ZoneSet: zoneset5
==========================================
Members
fibrechannel1/1/11
fibrechannel1/1/17
fibrechannel1/1/22
Supported
Releases
10.5.1.0 or later
show vfabric fspf
Displays FSPF information at the vfabric level.
Syntax
show vfabric fspf
Parameters None
Defaults Not applicable
Command Mode GLOBAL CONFIGURATION
Usage
Information
Use this command to display the FSPF information of an interface.
Example
OS10#show vfabric fspf
FSPF routing for vfabric 10
SPF hold time is 0 msec
MinLsArrival = 1000 msec , MinLsInterval = 5000 msec
Local Domain is 0x64 (100)
Number of LSRs = 3, Total Checksum = 0x0001288b
Refresh time = 1800 sec
Max age = 3600 sec
Statistic counters :
Number of SPF computations = 3
Number of checksum errors = 0
Number of transmitted packets : LSU 10 LSA 10 Hello 25 Retransmitted LSU
10
Number of received packets: LSU 10 LSA 10 Hello 25 Error packets 5
Supported
Releases
10.5.1.0 or later
Multi-hop FIP-snooping bridge
In typical deployments, ENode-connected switches are not directly connected to the core FC switch. Multiple intermediate
switches are connected in between the switches. To establish a point-to-point connection and for secure transmission between
the ENode and the FCF, all intermediate switches must support FSB to pass the FIP and FCoE traffic.
OS10 switches support the multi-hop FIP-snooping bridge. You can interconnect multiple FSBs to communicate with an
upstream FC switch.
● Access FSB— This is the node that is directly connected to ENode. In the following example, FSB1 is the access FSB.
● Core FSB— This is the node that is directly connected to the FCF. In the following example, FSB2 is the core FSB.
The default port mode is the ENode. You must explicitly configure the other modes using the fip-snooping port-mode
command. The following port modes are supported:
● ENode—Only one ENode MAC address per interface can be learnt. Configure this mode on the port connected to the
ENode.
● FCF—If you configure the FSB with FCF port mode, all the FIP packets sent between the ENode and the FCF are snooped
and the sessions and ENodes are learnt. Configure the FCF mode on the access FSB ports connected to the FCF-facing
side.
● ENode-transit—This mode is configured on the intermediate FSBs or Layer 2 (L2) DCBX switches to which ENodes are
connected.
372
Fibre Channel