Administrator Guide
bfd all-neighbors interval milliseconds min_rx milliseconds multiplier value role [active |
passive]
• Change parameters for all OSPF sessions on an interface.
INTERFACE mode
ip ospf bfd all-neighbors interval milliseconds min_rx milliseconds multiplier value role
[active | passive]
To view session parameters, use the show bfd neighbors detail command.
Disabling BFD for OSPF
If you disable BFD globally, all sessions are torn down and sessions on the remote system are placed in a Down state.
If you disable BFD on an interface, sessions on the interface are torn down and sessions on the remote system are placed in a Down state.
Disabling BFD does not trigger a change in BFD clients; a nal Admin Down packet is sent before the session is terminated.
To disable BFD sessions, use the following commands.
• Disable BFD sessions with all OSPF neighbors.
ROUTER-OSPF mode
no bfd all-neighbors
• Disable BFD sessions with all OSPF neighbors on an interface.
INTERFACE mode
ip ospf bfd all-neighbors disable
Congure BFD for IS-IS
When using BFD with IS-IS, the IS-IS protocol registers with the BFD manager on the RPM. BFD sessions are then established with all
neighboring interfaces participating in IS-IS. If a neighboring interface fails, the BFD agent on the line card noties the BFD manager, which
in turn noties the IS-IS protocol that a link state change occurred.
Conguring BFD for IS-IS is a two-step process:
1 Enable BFD globally.
2 Establish sessions for all or particular IS-IS neighbors.
Related Conguration Tasks
• Changing IS-IS Session Parameters
• Disabling BFD for IS-IS
158
Bidirectional Forwarding Detection (BFD)