Administrator Guide

CLI Command Mode Prompt Access Command
ROUTER RIP
Dell(conf-router_rip)# router rip
SPANNING TREE
Dell(config-span)# protocol spanning-tree 0
TRACE-LIST
Dell(conf-trace-acl)# ip trace-list
CLASS-MAP
Dell(config-class-map)# class-map
CONTROL-PLANE
Dell(conf-control-cpuqos)# control-plane-cpuqos
DHCP
Dell(config-dhcp)# ip dhcp server
DHCP POOL
Dell(config-dhcp-pool-name)#
pool (DHCP Mode)
ECMP
Dell(conf-ecmp-group-ecmp-
group-id)#
ecmp-group
EIS
Dell(conf-mgmt-eis)# management egress-interface-
selection
FRRP
Dell(conf-frrp-ring-id)# protocol frrp
LLDP Dell(conf-lldp)# or Dell(conf-if
—interface-lldp)#
protocol lldp (CONFIGURATION or
INTERFACE Modes)
LLDP MANAGEMENT INTERFACE
Dell(conf-lldp-mgmtIf)#
management-interface (LLDP Mode)
LINE Dell(config-line-console) or
Dell(config-line-vty)
line console orline vty
MONITOR SESSION
Dell(conf-mon-sess-sessionID)# monitor session
OPENFLOW INSTANCE
Dell(conf-of-instance-of-id)# openflow of-instance
PORT-CHANNEL FAILOVER-GROUP
Dell(conf-po-failover-grp)# port-channel failover-group
PRIORITY GROUP
Dell(conf-pg)# priority-group
PROTOCOL GVRP
Dell(config-gvrp)# protocol gvrp
QOS POLICY
Dell(conf-qos-policy-out-ets)# qos-policy-output
SUPPORTASSIST
Dell(support-assist)# support-assist
VLT DOMAIN
Dell(conf-vlt-domain)# vlt domain
VRRP
Dell(conf-if-interface-type-
slot/port-vrid-vrrp-group-id)#
vrrp-group
u-Boot
Dell=>
Press any key when the following line
appears on the console during a system
boot: Hit any key to stop
autoboot:
UPLINK STATE GROUP
Dell(conf-uplink-state-group-
groupID)#
uplink-state-group
The following example shows how to change the command mode from CONFIGURATION mode to PROTOCOL SPANNING TREE.
Example of Changing Command Modes
Dell(conf)#protocol spanning-tree 0
Dell(config-span)#
Conguration
Fundamentals 41