Administrator Guide
CONFIGURATION mode
arp backoff-time
The default is 30.
The range is from 1 to 3600.
• Display all ARP entries learned via gratuitous ARP.
EXEC Privilege mode
show arp retries
ICMP
For diagnostics, the internet control message protocol (ICMP) provides routing information to end stations by choosing the best route
(ICMP redirect messages) or determining if a router is reachable (ICMP Echo or Echo Reply).
ICMP error messages inform the router of problems in a particular packet. These messages are sent only on unicast trac.
Conguration Tasks for ICMP
The following lists the conguration tasks for ICMP.
• Enabling ICMP Unreachable Messages
For a complete listing of all commands related to ICMP, refer to the Dell Networking OS Command Line Reference Guide.
Enabling ICMP Unreachable Messages
By default, ICMP unreachable messages are disabled.
When enabled, ICMP unreachable messages are created and sent out all interfaces.
To disable and re-enable ICMP unreachable messages, use the following commands.
• To disable ICMP unreachable messages.
INTERFACE mode
no ip unreachable
• Set Dell Networking OS to create and send ICMP unreachable messages on the interface.
INTERFACE mode
ip unreachable
To view if ICMP unreachable messages are sent on the interface, use the show config command in INTERFACE mode. If it is not listed
in the
show config command output, it is enabled. Only non-default information is displayed in the show config command output.
UDP Helper
User datagram protocol (UDP) helper allows you to direct the forwarding IP/UDP broadcast trac by creating special broadcast addresses
and rewriting the destination IP address of packets to match those addresses.
Congure UDP Helper
To congure Dell Networking OS to direct UDP broadcast, enable UDP helper and specify the UDP ports for which trac is forwarded. See
Enabling UDP Helper
442
IPv4 Routing