Administrator Guide
Disabling and Undoing LLDP
To disable or undo LLDP, use the following command.
• Disable LLDP globally or for an interface.
disable
To undo an LLDP conguration, precede the relevant command with the keyword no.
Enabling LLDP on Management Ports
LLDP on management ports is enabled by default.
To enable LLDP on management ports, use the following command.
1 Enter Protocol LLDP mode.
CONFIGURATION mode
protocol lldp
2 Enter LLDP management-interface mode.
LLDP-MANAGEMENT-INTERFACE mode
management-interface
3 Enable LLDP.
PROTOCOL LLDP mode
no disable
Disabling and Undoing LLDP on Management Ports
To disable or undo LLDP on management ports, use the following command.
1 Enter Protocol LLDP mode.
CONFIGURATION mode.
protocol lldp
2 Enter LLDP management-interface mode.
LLDP-MANAGEMENT-INTERFACE mode.
management-interface
3 Enter the disable command.
LLDP-MANAGEMENT-INTERFACE mode.
To undo an LLDP management port conguration, precede the relevant command with the keyword no.
Advertising TLVs
You can congure the system to advertise TLVs out of all interfaces or out of specic interfaces.
• If you congure the system globally, all interfaces send LLDPDUs with the specied TLVs.
• If you congure an interface, only the interface sends LLDPDUs with the specied TLVs.
• If you congure LLDP both globally and at interface level, the interface level conguration overrides the global conguration.
538
Link Layer Discovery Protocol (LLDP)