Administrator Guide

Port Cost Default Value
25-Gigabit Ethernet interfaces 1700
40-Gigabit Ethernet interfaces 1400
50-Gigabit Ethernet interfaces 1200
100-Gigabit Ethernet interfaces 200
Port Channel with 100 Mb/s Ethernet interfaces 180000
Port Channel with 1-Gigabit Ethernet interfaces 18000
Port Channel with 10-Gigabit Ethernet interfaces 1800
Port Channel with 25-Gigabit Ethernet interfaces 1200
Port Channel with 50-Gigabit Ethernet interfaces 200
Port Channel with 100-Gigabit Ethernet interfaces 180
To change the port cost or priority of an interface, use the following commands.
1 Change the port cost of an interface.
INTERFACE mode
spanning-tree msti number cost cost
The range is from 0 to 200000.
For the default, refer to the default values shown in the table..
2 Change the port priority of an interface.
INTERFACE mode
spanning-tree msti number priority priority
The range is from 0 to 240, in increments of 16.
The default is 128.
To view the current values for these interface parameters, use the show config command from INTERFACE mode.
Conguring an EdgePort
The EdgePort feature enables interfaces to begin forwarding trac approximately 30 seconds sooner.
In this mode, an interface forwards frames by default until it receives a BPDU that indicates that it should behave otherwise; it does not go
through the Learning and Listening states. The bpduguard shutdown-on-violation option causes the interface hardware to be
shut down when it receives a BPDU. When you implement only bpduguard, although the interface is placed in an Error Disabled state
when receiving the BPDU, the physical interface remains up and spanning-tree drops packets in the hardware after a BPDU violation.
BPDUs are dropped in the software after receiving the BPDU violation. This feature is the same as PortFast mode in spanning tree.
CAUTION
: Congure EdgePort only on links connecting to an end station. EdgePort can cause loops if you enable it on an
interface connected to a network.
To enable EdgePort on an interface, use the following command.
• Enable EdgePort on an interface.
INTERFACE mode
spanning-tree mstp edge-port [bpduguard | shutdown-on-violation]
Dell Networking OS Behavior: Regarding bpduguard shutdown-on-violation behavior:
582
Multiple Spanning Tree Protocol (MSTP)