Concept Guide

– For a Null interface, enter the keyword null then the Null interface number.
– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Conguring Telnet with IPv6
The Telnet client and server in Dell EMC Networking OS supports IPv6 connections. You can establish a Telnet session directly to the router
using an IPv6 Telnet client, or you can initiate an IPv6 Telnet connection from the router.
NOTE: Telnet to link local addresses is supported on the system.
• Enter the IPv6 Address for the device.
EXEC mode or EXEC Privileged mode
telnet [vrf vrf-name] ipv6 address
– ipv6 address: x:x:x:x::x
– mask: prex length is from 0 to 128.
NOTE: IPv6 addresses are normally written as eight groups of four hexadecimal digits, where each group is separated by a
colon (:). Omitting zeros is accepted as described in Addressing.
SNMP over IPv6
You can congure SNMP over IPv6 transport so that an IPv6 host can perform SNMP queries and receive SNMP notications from a
device running Dell EMC Networking OS IPv6. The Dell EMC Networking OS SNMP-server commands for IPv6 have been extended to
support IPv6. For more information regarding SNMP commands, refer to the SNMP and SYSLOG chapters in the Dell EMC Networking OS
Command Line Interface Reference Guide.
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Displaying IPv6 Information
View specic IPv6 conguration with the following commands.
• List the IPv6 show options.
EXEC mode or EXEC Privileged mode
show ipv6 ?
Example of show ipv6 Command Options
DellEMC#show ipv6 ?
accounting IPv6 accounting information
cam IPv6 CAM Entries
fib IPv6 FIB Entries
interface IPv6 interface information
mbgproutes MBGP routing table
mld MLD information
mroute IPv6 multicast-routing table
neighbors IPv6 neighbor information
IPv6 Routing
507