Connectivity Guide

Supported Releases 10.2.0E or later
trust-map
Congures trust map on an interface or on a system QoS.
Syntax
trust—map {dot1p | dscp} {default | trust-map-name}
Parameters
• dot1p — Apply dot1p trust map.
• dscp — Apply dscp trust map.
• default — Apply default dot1p or dscp trust map.
• trust-map-name — Enter the name of trust map.
Default Disabled
Command Mode
INTERFACE
SYSTEM-QoS
Usage Information The no version of this command removes the applied trust map from the interface or system QoS.
Example
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# trust-map dot1p default
OS10(conf-if-eth1/1/10)# trust-map dot1p d1
OS10(config)# interface ethernet 1/1/2
OS10(conf-if-eth1/1/2)# trust-map dscp default
OS10(conf-if-eth1/1/2)# trust-map dscp d2
OS10(config)# system qos
OS10(config-sys-qos)# trust-map dot1p default
OS10(config-sys-qos)# trust-map dscp d2
Supported Releases 10.4.1.0 or later
trust dot1p-map
Creates a user-dened trust map for dot1p ows.
Syntax
trust dot1p-map map-name
Parameters map-name — Enter the name of the dot1p trust map. A maximum of 32 characters.
Default Not congured
Command Mode CONFIGURATION
Usage Information If you enable trust, trac obeys the dot1p map. default-dot1p-trust is a reserved trust-map name. The no
version of this command returns the value to the default.
Example
OS10(config)# trust dot1p-map map1
OS10(config-tmap-dot1p-map)# qos-group 4 dot1p 5
Supported Releases 10.3.0E or later
Quality of service 1031